Calibrate any Enode hardware

Once a sensor is connected, you will see a real-time 3D representation with 6 marked sides. Now you can just place the sensor briefly on each side, and it is calibrated for accurate measurements. Calibration is not always needed. The sensor decides if it's necessary or not. Manual calibration can also be performed without direct feedback from the app. To do this, place the sensor on each of the 6 sides for about 3 seconds. In the background, the sensor is thereby also recalibrated, which can help with any measurement problems. Additionally, if you tap where the battery status of the sensor is shown in the top left of the training screen, a box will pop up with the option to calibrate.

For the Bar Sensor Kit, pay attention to the markings on the sides to place the sensor according to the markings in the app.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us